TA Triumph-Adler P-4035 MFP - Manual (Page 169)

8-5
Fax Settings > Default fax settings
Local FAX Name Register the local FAX name printed in the transmit terminal identification (TTI) area.
Refer to Local FAX Name on page 2-8 .
Local FAX ID Register the local FAX ID.
Refer to Local FAX ID on page 2-10 .
NOTE
The Local FAX ID is used for transmission limit purposes. Refer to Transmission
Restriction on page 8-9 .
Local FAX Number Register the local FAX number printed in the transmit terminal identification (TTI) area.
Refer to Local FAX Number on page 2-9 .
FAX Dialing Mode Select the telephone line according to the type you are contracted with. Please note that
selecting a wrong telephone line will prevent you from sending fax.
Refer to FAX Dialing Mode on page 2-10 .
NOTE
This setting does not appear in some regions.
Retry Times The number of retry times can be changed automatically.
ECM TX Set whether ECM TX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value : On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
TX Start Speed Set the TX Start Speed.
When communication conditions are bad, the fax may not be transmitted correctly. In that case,
set a lower TX Start Speed.
Value : 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Item Description