Sleep and auto sleep, Sleep and auto sleep -15 – TA Triumph-Adler 3005ci User Manual
Page 119
3-15
Preparation before Use > Energy Saver function
Sleep and Auto Sleep
Sleep
To enter Sleep, press the [
Power
] key. Touch panel and all indicators on the operation panel will go out to save a
maximum amount of power except the Main Power indicator. This status is referred to as Sleep.
If print data is received during Sleep, the print job is performed while the touch panel remains unlit.
When using the optional fax, received fax data is printed out while the operation panel also remains unlit.
•
Press the touch panel or any key on the operation panel.
The machine will be ready to use within 20 seconds for 3005ci, 20 seconds for 3505ci, 28 seconds for 4505ci, and 30
seconds for 5505ci.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time are 30 minutes for 3005ci, 45 minutes for 3505ci, and 60 minutes for 4505ci/5505ci.
To change the preset sleep time, refer to
.
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, it cannot perform
printing from a computer connected by USB cable. In addition, it takes longer for the machine to wake and return to
normal operation. Also, the ID card cannot be recognized.
For more information on Sleep Rules settings, refer to
Sleep Rules (models for Europe) on page 8-55
Sleep Level (Energy Saver) (models except for Europe)
This mode reduces power consumption even more than normal Sleep mode, and allows Sleep Mode to be set separately for each
function. Printing from a computer connected with a USB cable is not available while the machine is asleep. The time required for
the machine to wake up from power save mode and resume normal operation will be longer than for normal Sleep Mode.
For more information on Energy Saver Mode settings, refer to
Sleep Level (models except for Europe) on page 8-56
.
Energy Saver Recovery Level
This machine can reduce power consumption when recovering from Energy Saver Mode.
For EnergySaver RecoveryLevel, "Full Recovery", "Normal Recovery" or "Power Saving Recovery" can be selected.
The factory default is "Normal Recovery".
For more information on Energy Saver Mode settings, refer to
EnergySaver RecoveryLevel on page 8-56
.
NOTE
This function cannot be turned on in some regions.
NOTE
If the optional network interface kit and Fiery controller are installed, Energy Saver cannot be specified.
Main Power
indicator