TA Triumph-Adler CX 8036 - Manual (Page 153)

Section 7 AutoCAD HDI Driver 7-15
5.2.4 Stamp
This button allows a stamp which is predetermined in the Request
Software to be placed on the print(s). The creation and placement of the
stamp is again preformed in the request application.(see KIP Request
Software Guide)
5.3 Media Options
5.3.1 Type
This drop down list has the listed media types that may be installed in the
KIP printer. They include Bond, Vellum and Film. Please note the Status
region to confirm the media currently installed. If a media selected for a
print is not currently installed, the printer will “hold the job” and wait for the
media type to be satisfied prior printing the job.
5.3.2
Fold
Uses the fold patterns configured on the KIP IPS when selected. Please
note that the optional folder must be installed for this action to occur.
5.3.3 Save Paper
If the media size selected is larger than the image size, this button will
prevent excess media (wasted) from being consumed in the print process.
This occurs in the length of the print. This does not affect image output.
Note: If the Printer is set to “Closest“ the nearest roll width installed will be
used to even further reduce media waste. (more than one roll width must
be installed of the same type)