TA Triumph-Adler CX 8036 - Manual (Page 103)

5-9 Section 5 Help-Configuration
User Configuration Service Configuration
a) Set the timers by pressing on the hour, minutes and AM/PM as
needed.
b) If the printer is required during the “sleep” period, it will simply
awake, produce the prints and then “fall asleep“ again, 15 minutes
later.
4.5 Reset Timer
Systems can be configured to revert to the
Log-In screen after a predetermined time of inactivity.
From this screen, users must enter a username and
password before use (if required by system
administrator).
4.6 Printer Density
Sets the printer density for all
images, including copy and
print jobs.
NOTE
Other sleep timer are also available on the system set only by the
technician. These other timers set the printer to sleep within a certain number
of minutes after last use, and can be awaken by network or copy job. This
places the printer into warm or cold sleep as well.
Please contact your local technician if this form of timer is required to reduce
power consumption not settable by the user.