TA Triumph-Adler CX 8036 - Manual (Page 104)

5-10 Section 5 Help-Configuration
4.7 Default Mode
Sets which Screen will be the default Mode, Scan or Copy Mode
dependent of the installation environment requirements.
4.8 Default Original Size – STF
Either Engineering or Architectural sizes can be set as the default width
detection in Scan Mode. This will allow automatic width detection of
either one of the two formats.
Engineering widths = 34, 22, 17, 11, and 8.5 inches
Architecture widths = 36, 30, 24, 18, 12, and 9 inches
4.9 Default Original Size – Copy
Either Engineering or Architectural sizes can be set as the default width
detection in Copy Mode. This will allow automatic width detection of
either one of the two formats.
Engineering widths = 34, 22, 17, 11, and 8.5 inches
Architecture widths = 36, 30, 24, 18, 12, and 9 inches
4.10 Copy and Scan Menu Defaults
Each system provides powerful options regarding the preferred condition of
the system upon start up. System operators may designate features to be
active when the system is powered on to ensure fast use.
1) Set up copy or scan main menu to the desired active features
2) Access the configurations menu by depressing (?)
3) Select the “Configuration” button
4) Press the “Set Copy Defaults” or “Set Scan Defaults” button located on page
4.
5) Presets for either the Copy or Scan screens have now been designated.