Troubleshooting, Solving malfunctions, Troubleshooting -9 – TA Triumph-Adler P-C3560DN User Manual
Page 194: Solving malfunctions -9
10-9
Troubleshooting > Troubleshooting
Troubleshooting
Solving Malfunctions
The table below provides general guidelines for problem solving.
If a problem occurs with your machine, look into the checkpoints and perform procedures indicated on the following
pages. If the problem persists, contact your Service Representative.
NOTE
When contacting us, the serial number will be necessary.
To check the serial number, refer to the following:
Checking the Equipment's Serial Number (page 5-2)
Symptom
Checkpoints
Corrective Actions
Reference
Page
The screen does not
respond when the main
power switch is turned on.
Check the power cord.
Connect both ends of the power cord
securely.
Blank sheets are ejected.
Are the originals loaded correctly?
Check that the settings of the
application software.
―
Printouts are totally too light. Is the paper damp?
Replace the paper with new paper.
Is the toner distributed evenly within the
toner container?
Shake the toner container from side to
side several times.
Is EcoPrint mode enabled?
Disable [EcoPrint] mode.
―
Select the [Menu] key > [Adjust/Maint.]
> [Service Setting] > [Drum], and then
select [Yes].
―
―
Make sure the paper type setting is
correct for the paper being used.
Printouts are fuzzy.
Is the machine being used in conditions
of very humid, or humidity or
temperature rapidly changes?
Use in an environment that has suitable
humidity.
―
―
Select the [Menu] key > [Adjust/Maint.]
> [Service Setting] > [Drum], and then
select [Yes].
―
Images are skewed.
Is the paper loaded correctly?
Check the position of the paper width
guides.