Rugged Cams ELX DVR 16 Channel - Manual (Page 13)

Basic Configuration ELX16-240
Rugged CCTV.
2003.09.06 (v 1.0) 13
3.4. Viewing all channels with sequence mode
There are two modes; basic sequence mode and user sequence mode. User sequence mode runs when
pressing the [SEQ] button during 1 second or above.
3.4.1. Basic sequence mode
- All channels can be viewed in successive order automatically using the [SEQ] button.
- Press the [MENU] button on the front panel to set -up the sequential cycle. (The default value is 3
seconds per channel for display .)
- Select “M onitor A ” menu of “Monitor” tab among Configuration menus. And press the [ENTER] button.
- Select “Seq. Switching(sec) ” and set any value between 1 and 60 seconds.
- In order to move to sequence mode from any viewer mode, press the [SEQ] button.
- In order to exit from sequence mode, press the [SEQ] button once again.
Sequence mode can run only when connected and activated cameras are more than split screen. With
single full screen mode, activated cameras should be two or more. With quad-sp lit screen mode, there
should be five or more activated cameras . In 16 / 13 spilit mode, sequence mode can’t be used.