RISCO Group WatchIN Industrial Grade 3 Detector - Manual (Page 8)

WatchIN Installation Manual 6
LEDs Display
LED State Description
YELLOW
Steady Indicates PIR detection
Flashing Indicates AM (Anti mask) detection
GREEN
Steady Indicates MW detection
RED
Steady Indicates ALARM
Flashing Indicates malfunctioned communication with ProSYS (BUS
mode only)
All LEDs
Flashing (One after
another) Unit initialization on power up
Notes:
1. DIP-Switch 1 should be in ON position to enable LED indications.
2. Only one LED is active at any one time. For example, in the case of both PIR and MW detection, either the
steady YELLOW LED or the steady GREEN LED is displayed (the first to detect), followed by the Alarm RED
LED.
Relay Mode / BUS Mode Jumper
J-BUS jumper (located on the PCB between the red and green LEDs)
is used to define the detector’s mode of operation as follows:
Relay
Mode BUS
Mode