Precision Digital PD865 - Manual (Page 27)

PD865 Snooper Modbus Serial Input Meter Instruction Manual
27
Display Parameter Action/Setting
Disp.dp Display
Decimal
Point Set the decimal point position for the display.
This is independent from float decimal point.
FLot.dP
Float
Decimal
Point Select the decimal point for the expected floating
point data.
Scale
Scale Enter the Scaling menu.
inP 1
Input
Point 1 Enter the Input value for point 1. Up to 16 points
can be entered in Linear mode.
dis 1
Display
Point 1 Enter the Display value for point 1. Up to 16
points can be entered in Linear mode.
save ? Save? Press Enter to save scaling data. Press Menu to
exit without saving.
RELaY
Relay Enter the Relay menu.
RLY1 Relay1 Relay 1 setup. Similar menus for Relays 2 to 4
are not shown here.
Act1
Action1 Set relay 1 action (automatic, latching, etc.).
Auto Automatic Set relay for automatic reset.
A-nman
Auto-
manual Set relay for automatic + manual reset any time.
LatCH Latching Set relay for latching operation.
Lt-CLr
Latching-
cleared Set relay for latching operation with manual reset
only after alarm condition has cleared.
Altern Alternate Set relays for pump alternation control.
oFF
Off Disable relay and front panel status LEDs.
Disable relay fail-safe operation.
Set1 Set1 Program set point for Relay 1.
rSt1 Reset1 Program reset point for Relay 1.
FaiLSF
Fail-safe Enter Fail-safe menu.
FLS 1 Fail-safe1 Set relay 1 fail-safe operation. Similar menus for
Relays 2 to 4 are not shown here.
on
On Enable fail-safe operation.
off Off Disable fail-safe operation.
DeLAY Delay Enter Time Delay menu.