Epson Z8250NL - Manual (Page 98)

Problem Solving
98
Lamp Error
Lamp Failure
Check the following two points.
• Take out both lamps and check if they are cracked. s
p.119
• Clean the air filter. s p.116
If it is not cracked: Re-fit the lamp and turn on the power.
If the error continues: Replace the lamp with a new lamp and turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and
contact Epson. s
p.114
If it is cracked: Replace it with a new lamp, or contact Epson for further advice. If replacing the lamp yourself,
be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced).
s
p.114
When using at an altitude of 4921 ft (1500 m) or more, set High Altitude Mode to On. s p.67
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down when the projector is installed
in a direction which is not horizontal. s
p.67
Filter Airflow Error Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s
p.116 , p.122
If the error continues after checking the points above, stop using the projector, disconnect the power cable
from the electrical outlet, and contact Epson. s
p.114
Auto Iris Error
Cinema filter error
Shutter Error
Power Err. (Ballast)
Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114
Status Cause Remedy or Status