Epson Z8250NL - Manual (Page 160)

Adjusting the Projected Image
160
B
Press the [h] button on the remote control in the [r]
direction or press the [Enter] button on the control panel to
switch the test pattern.
To display the previous image, press the [h] button on the remote
control in the [l] direction.
The following adjustments can be made while the test pattern is be-
ing displayed.
*1 Except for custom settings of gamma
*2 Not available on PowerLite Pro Z8150NL
q To set menu items that cannot be set while the test pattern is being
displayed or to fine-tune the projected image, project an image from the
connected device.
C
Press the [Esc] button to end the test pattern.
Using the Remote Control Using the Control Panel
Top Menu Sub Menu/Items
Image menu Color Mode s p.34
Abs. Color Temp.
Advanced
- Gamma *1 s p.171
- RGB
- RGBCMY s
p.171
Auto Iris
Reset
Signal menu Auto Setup
Settings menu Geometric Correction s p.163
Extended menu Multi-Projection
- Brightness Level
*2
- Edge Blending s p.180
- Multi-screen s p.182