Canon i-SENSYS MF244dw - Manual (Page 34)

7
Click [Add Port] → select the type of port ([Standard TCP/IP Port] or [Network]) from
[Port to Add] → click [OK].
When adding a network printer port:
Select the network printer to use → click [OK] → proceed to step 8.(P. 31)
When adding a standard TCP/IP port:
Enter the device name or IP address according to the instructions of the wizard.
[Port Name] is automatically entered. Change the port name if required.
NOTE
● If the [Additional Port Information Required] or [Additional port information required] screen is displayed,
perform one of the following procedures.
- Return to the previous screen in the wizard → re-enter the information in [Hostname or IP address] → click
[Next].
- Select [Standard] for [Device Type] → select [Canon Network Printing Device with P9100] → click [Next].
Depending on the device you are using, the type of device that you can select in the [Additional Port
Information Required] or [Additional port information required] screen > [Device Type] > [Standard] may
vary.
8
Select [Printer Name] if necessary → click [Next].
[Set as Default]: Select this to set the device as the device that is normally used.
To enable the above setting in Windows 10, check that the following setting is disabled in Windows.
[Settings] > [Devices] > [Printers & scanners] > [Let Windows manage my default printer]
[Use as Shared Printer]: Select this if you want to configure shared settings for the device.
If you added or selected a network printer port, you cannot set [Printer Name] and [Use as Shared Printer].
Installation Using the Installer
31