MCZ Duo HYDRO AIR - Manual (Page 44)

44
16-CLEANING AND MAINTENANCE
• Remove the top “1”
• Remove the 4 screws “2”
• Remove the two profile supports “3”
To avoid removing the entire cladding, block the two front profiles with two clamps “4”.
• Remove the four screws “5” and as a result remove the two plates of the turbulator rods “6”
• Loosen the two screws “7”, remove the two screws “8” and remove the entire fan block “9”
• Remove the exchanger “10”
• Loosen the two screws “11”, remove the two screws “12” and remove the exchanger support “13”
• Loosen the two screws “14” and remove the rods “15”
• Remove the two screws with shims “16” and the stove cover “17”
• Remove the turbulators “18”
At this point, using a rod or a brush for cleaning bottles, clean inside the pipe unit and the pipes, removing any ash deposits.
Check the cover seal “17” and replace it if necessary.
It is obligatory to have an authorised and skilled technician perform the periodic end-of-season cleaning in order
to replace any worn gaskets.
CLEANING THE SMOKE EXHAUST SYSTEM AND GENERAL CHECKS
Clean the smoke extractor system, especially around the “T” joints, elbows and any horizontal sections of the smoke duct.
For information on periodically cleaning the flue, contact a skilled chimney sweep.
Check the seal of the ceramic fibre gaskets on the door of the stove. If necessary, order new replacement seals from the retailer or contact
an authorized service centre to carry out this task.
CAUTION:
The frequency with which the smoke outlet system is cleaned depends on the use of the boiler and the type of
installation.
We recommend relying on an authorised service centre for end-of-season cleaning and maintenance, as they will
carry out all of the previously mentioned work and inspect the stove components.
SHUTDOWN (end of season)
At the end of each season, before switching the product off, it is recommended to remove all the pellets from the hopper with a vacuum
cleaner with a long pipe.
When not in use the appliance must be disconnected from the mains power supply. It is recommended to remove the
power cable for additional safety, especially in the presence of children.
The service fuse may have to be replaced if the control panel display does not switch on when the product is switched on again by pressing
the main switch on its side.
There is a fuse compartment on the back of the product, under the power socket. After having disconnected the plug from the socket, use
a screwdriver to open the cover of the fuse compartment and if necessary, replace them (3.15 A delayed).