MCZ Duo HYDRO AIR - Manual (Page 18)

18
12-SETTINGS MENU
PELLET RECIPE
This function is for adapting the stove to the type of pellet in use. As there are many types of pellet available on the market, stove
operation can vary considerably according to the quality of the fuel. When the pellets clog up the brazier due to excess loading of fuel,
vice-versa if the flame has a tendency to shut-off, it is possible to decrease/increase the amount of pellets in the brazier:
The available values compared to factory settings are:
+15% +10% + 5%; 0%; -10% -20% -30%
To modify the pellet recipe, in sequence, press:
from the Settings menu- press ok (E key), press the D KEY (arrow) scroll up to pellet recipe and press OK (E key) and enter the function,
using the "C" and "D" keys to modify the parameter and press Ok ("E" key).
ACTIVE +
The pellet type is not a problem because the stoves are equipped with the Active system and automatically adapt to pellet of any length
with a diameter of 6-8 mm. Effective and efficient combustion is independent from any type of connection to the flue which, with
traditional systems, may constitute a problem during the installation phase.
Thanks to an internal sensor, the stove is extremely reliable and precise. Combustion air is constantly adjusted based on the quantity of
pellets present in the brazier, guaranteeing an effective and efficient combustion this way that translates into decreased consumption,
emissions and less frequent cleaning.
Thanks to Active plus, it is possible to control and communicate with the stove, even by way of Smartphone and tablet. Since it is possible
to manage more evolved gear motors (with continuous operation), and the new pellet stoves equipped with active plus are more silent.
This function is used to adjust combustion air if the flame is too high or too low.
It can be activated from the SETTINGS menu, scroll using the “D” arrow key up to the “Ricetta Aria” (Air recipe) function, press OK using the
“E” key, and, using the “D” arrow key modify the parameter and press “ok” “E” key.
The fixed parameters that can be set are: +10; +5; -5; -10
B
E
INFO OK
C
D
B
EXIT
CHANGE BY PERCENT THE FEED SCREW
SPEED TO ADAPT THE STOVE TO THE TYPE
OF PELLET
SETTINGS-LOAD-RECIPE
+15%
B
E
INFO OK
D
B
EXIT
CORRECT THE LEVEL OF
COMBURENT AIR
SETTINGS-SMOKE FAN
0%