MCZ Vivo 90 Pellet Comfort Air User Manual

Page 41

°C

MAN

21:11

OFF

23:00

MAX

°C

9-REMOTE CONTROL MAX

SUNDRY SETTINGS

Room ventilation

Room ventilation can be adjusted as desired in all 4 operating modes described above. Simply perform this operation: from the basic

display, press key D to access the VENTILATION adjustment mode (figure 6). Then press key C to set the desired ventilation by selecting

one of the 5 levels available, independent from the flame level. The “auto” option can also be selected, which automatically links the room

ventilation speed to the flame level.

In short:

flame set on 1 > ventilation set on 1; flame set on 3 > ventilation set on 3; flame set on 5 > ventilation remains set on 3 (to make

operation more

silent as it is in automatic mode).

In products with 2 room fans (comfort air models) via key D one can scroll and set the speed of the individual fans

(identified with 1 or 2 above the level bars).

NOTE: In the event a replacement remote control is purchased, if you need to change the default setting, proceed as

follows: with the remote control switched on press buttons D + E at the same time for 10 seconds (until the flashing

number appears). Press key C to select 1 or 2 according to the product to which the remote control is to be paired, and

press E to exit.

Sleep function

The sleep mode allows to quickly set the time at which the product must switch off. This function is only available in MAN and AUTO mode.

It is set as follows: from the VENTILATION setting (by pressing key D - see previous paragraph), press key D again to access the SLEEP mode

setting.

Via key C one can adjust the shutdown time in 10 minute intervals.

By confirming with D or E one goes back to the basic display, in which the sleep mode shutdown time is any case visible (figure 7).

To disable the SLEEP mode simply access the settings, decrease the time until the dashes appear and confirm.

FIG.6

FIG.7