Epson COLOR Copy Station 8600 - Manual (Page 229)

Tips for Administrator 229
5
5
5
5
5
5
5
5
5
5
5
5
❏ Choose Panel when setting the IP address, subnet mask,
and default gateway using the printer’s control panel.
❏ Choose Auto when getting the IP address from a DHCP
server. The IP address is automatically obtained from the
DHCP server whenever the printer is reset or turned on.
❏ Choose PING when setting the IP address using the
arp/ping command. The network interface uses the IP
address set by the arp/ping command. The settings
become available when the printer is reset or turned off
and then back on.
Note:
❏ To use Auto, a DHCP server must be correctly configured on
the network. See the online help of your operating system for
detailed instructions.
❏ Choose PING only when setting the IP address using the
arp/ping command.
7. Press the Up or Down button until IP = xxx.xxx.xxx.xxx
appears. Press the Enter button.
8. Press the Up or Down button until the desired value appears.
Then press the Enter button to set the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default
gateway.
9. Press the Start button to exit the control panel menus.
10. Turn off your printer and then turn it back on. Be sure to wait
until the initialization is complete.
Print a network status sheet to confirm the new IP address.