Network interface operation, Status lights, Network connector – Epson COLOR Copy Station 8600 User Manual
Page 15: About the software, Status lights network connector

Introduction
15
1
1
1
1
1
1
1
1
1
1
1
1
Network Interface Operation
Status lights
The indicator lights (one green and one orange) provide you with
important information on the operations of the network interface.
The green light is a data transmission light that flashes when the
host interface receives data.
The orange light indicates whether the network interface is
connected to 10Base-T or 100Base-TX. The light is on when the
connection is 100Base-TX, or off when the connection is 10Base-T.
Network connector
RJ-45 connector: This connector is used to connect an Ethernet
cable to a network. You can use this cable for both 10Base-T and
100Base-TX.
c
Caution:
You must use a Category-5 shielded twisted-pair cable to connect
the network interface to a network to prevent malfunctions.
About the Software
❏ EpsonNet Config for Windows is a Windows-based
configuration utility for administrators that allows you to
configure the network interface for various protocols such as
TCP/IP, NetWare, MS Network, AppleTalk, IPP, and SNMP.
See "EpsonNet Config for Windows" on page 135.