Extron electronic MEDIALINK MLC 52 - Manual (Page 98)

Serial Communication, cont’d
MLC 52 Series MediaLink Controllers • Serial Communication 5-38
The Volume knob cannot be configured using the configuration
software.
3 The two buttons in the right column, below the Display Off button, are
configured as follows:
• MLC 52 standard models: These buttons are in input mode, colored
blue, and are labeled “PC” and “Video.”
• MLC 52 VC models: One button is in input mode (blue) and is labeled
“PC”; the other button is in single-switch mode (gray) and is
unlabeled.
These buttons can be in either input or single switch mode on all models.
IR 452: The Power On and Power Off buttons on the IR 452 remote control are in
power mode and are tied to the MLC Display On and Off buttons. These are the
only IR 452 buttons that are programmed with functions and configured in a
switch mode. Switch modes are not available for the other IR 452 buttons.
Setting the button modes
To change the button mode or switch mode of a button,
1 . Click on the MLC or IR 452 button that you want to set up.
For the IR 452 buttons, only the button mode (toggle or macro) can be set.
2 . From the Switch Mode or Button Mode drop-down box, select the mode for
the button you selected in step 1.
Switch Mode menu for a volume button
The screen button changes color to reflect its new mode.
Entering display device power settings
The Display Power Settings tab lets you make some specifications regarding
power settings for your projector or display.
When you make a selection in any of the first three fields, the Apply and Cancel
buttons on this tab are enabled and the text on them becomes red. Click Apply to
implement the change(s) you made, or click Cancel if you want to clear settings
that have not been applied.
Display Power Settings tab