Using lanview, Using lanview -2, C2k122-24 lanview leds -2 – Enterasys Networks C2K122-24 User Manual
Page 58: Using lanview 4-2 troubleshooting
Using LANVIEW
4-2 Troubleshooting
Using LANVIEW
The switch supports the Enterasys Networks built‐in LANVIEW LED visual diagnostic
and status monitoring system. The location of each C2K122‐24 LANVIEW LED is shown
in
. The LEDs enable you to quickly observe network status for diagnosing
switch and network problems.
Figure 4-1 C2K122-24 LANVIEW LEDs
describes the LED indications and provides recommended actions as
appropriate.
1 CPU LED
6 Link/Activity LED for 10/100/1000 Mbps,
2 STACK DOWN LED
port 1 of the 24 RJ45 ports
3 STACK UP LED
7 Link/Activity LEDs for 10-Gbps XFP ports,
4 RPS LED for redundant power-source status
25 and 26
5 Manager LED
Note: The terms flashing, blinking, and solid used in
indicate the following:
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
Console
1
2
23
24
25
26
CPU
UP
RPS
MGR
DOWN
13
14
11
12
25
26
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
C2K122-24
TX RX
TX RX
1
2
CPU
UP
RPS
DOWN
А
Б
В
Г
Д
Е
Ж
MGR