Enterasys Networks C2K122-24 - Manual (Page 35)

Installing the Switch on a Flat Surface
SecureStack C2 Installation Guide 3-5
To remove an XFP from a port slot, refer back to Figure 3‐1 , and proceed as follows:
1. Attach your antistatic wrist strap (refer to the instructions in your antistatic wrist
strap package) before removing the XFP.
2. Remove the cable connected to the XFP.
3. Locate the XFP wire handle and pull down on it to release the XFP.
4. Grasp the sides of the XFP and pull it straight out of the port slot.
If storing or shipping an XFP, which has a fiber‐optic connector, insert its protective dust
cover to protect the ends of the fiber‐optic fibers from dust or contamination.
Installing the Switch on a Flat Surface
When installing the switch on a flat surface, the installation of the rubber feet is
recommended to prevent the switch from sliding on a flat surface. Installing the rubber
feet is optional if you are installing the switch in a rack. To install the rubber feet, proceed
to “
Installing the Rubber Feet ” instructions below. For instructions to rack mount the
switch, proceed to “ Rack Mounting the Switch ” on page 3‐7.
Installing the Rubber Feet
To install the rubber feet, refer to Figure 3‐2 and proceed as follows:
1. Place the switch on its back on a sturdy flat surface to gain access to the bottom of the
chassis.
2. Remove the four rubber feet from their plastic bag in the shipping box.
3. Locate the four marked locations on the bottom four corners of the chassis.