Enterasys Networks C2K122-24 - Manual (Page 24)

Management
1-4 Introduction
Management
Management of the module can be either in‐band or out‐of‐band. In‐band remote
management is possible using Telnet, Enterasys Networks’ NetSight
®
management
application, or the WebView application. Out‐of‐band management is provided through
the DB9 console port on the front panel using a VT100 terminal or a VT100 terminal
emulator.
Switch Configuration Using WebView
Enterasys Networks’ HTTP‐based Web management application (WebView) is an
intuitive web tool for simple management tasks.
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete switch configuration
management tasks.
For CLI command set information and how to configure the module, refer to the
SecureStack C2 Configuration Guide.
Standards Compatibility
The switches are fully compliant with the IEEE 802.3‐2002, 802.3ae‐2002, 802.1D‐1998, and
802.1Q‐1998 standards. The switches provide IEEE 802.1D‐1998 Spanning Tree Algorithm
(STA) support to enhance the overall reliability of the network and protect against “loop”
conditions.
LANVIEW Diagnostic LEDs
LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an
easy way to observe the status of individual ports and overall network operations.