Guidelines for rackmount installation, Attaching brackets and installing in rack, Attaching the rackmount brackets -8 – Enterasys Networks C2K122-24 User Manual
Page 38: Ба б а
Rack Mounting the Switch
3-8 Hardware Installation
Guidelines for Rackmount Installation
The installation site must be within reach of the network cabling and meet the
requirements listed below:
•
Appropriate grounded power receptacles must be located within 152 cm (5 ft) of the
location.
•
A temperature of between 5°C (41°F) and 40°C (104°F) must be maintained at the
installation site with fluctuations of less than 10°C (18°F) per hour.
Attaching Brackets and Installing in Rack
Proceed as follows to install the switch into a 19‐inch rack:
1.
Attach the rackmount brackets to the switch, as shown in
, using the eight
M3 x 6 mm flathead screws shipped with the switch.
Figure 3-4 Attaching the Rackmount Brackets
2.
With the mounting brackets attached, position the switch between the vertical frame
members of the 19‐inch rack as shown in
. Then fasten the switch securely
to the frame using four mounting screws (user supplied).
Note: To ensure proper ventilation and prevent overheating, leave a minimum clearance
space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.
Warning: Before rack-mounting the device, ensure that the rack can support it without
compromising stability. Otherwise, personal injury and/or equipment damage may result.
Advertencia: Antes de montar el equipo en el rack, asegurarse que el rack puede
soportar su peso sin comprometer su propia estabilidad, de otra forma, daño personal o
del equipo puede ocurrir.
Warnhinweis: Überzeugen Sie sich vor dem Einbau des Gerätes in das Rack von dessen
Stabilität, ansonsten könnten Personenschäden oder Schäden am Gerät die Folge sein.
1 Rackmount brackets
2 M3 x 6 mm flathead screws
Б
А
Б
А
Console
1
2
23
24
25
26
CPU
UP
RPS
MGR
DOWN
13
14
11
12
25
26
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
C2K122-24
TX RX
TX RX