Rack mounting the switch, Rack mounting the switch -7, Figure 3‐3 – Enterasys Networks C2K122-24 User Manual
Page 37: Аг в б
Rack Mounting the Switch
SecureStack C2 Installation Guide 3-7
The next step to install the switch is dependent on the type of installation. If installing
several switches in a stack, proceed to “
Connecting High‐Speed Stacking Cables
page 3‐9. If installing the switch as a standalone device, proceed to “
” on page 3‐13 for power connection instructions.
Figure 3-3 Area Guidelines for Switch Installation on Flat Surface
Rack Mounting the Switch
To install the switch in a 19‐inch rack, you need:
•
Two rackmount brackets and mounting screws (rackmount kit) shipped with the
switch.
•
Four user‐supplied screws to attach the switch to a standard 19‐inch rack.
Caution: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in) at the left, right, and rear of the switch.
Do not connect the switch to the AC power source until instructed to do so later in the
installation process.
Precaución: Para asegurar una buena ventilación y evitar que el sistema se
sobrecaliente, deje un espacio mínimo de 5.1 cm (2 pulgadas) con respecto a los lados y
a la parte posterior del aparato.
1 Approximately 152 cm (5 ft) from power source
3 44.5 cm (19.4 in.) for proper ventilation
2 4.45 cm (1.75 in.) per switch. (Vertical clearance
depends on number of switches stacked.)
4 419.0 cm (16.5 in.) for proper ventilation
А
Г
В
Б
Console
1
2
23
24
25
26
CPU
UP
RPS
MGR
DOWN
13
14
11
12
25
26
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
C2K122-24
TX RX
TX RX