Edge Products ES3528-WDM - Manual (Page 66)

Basic Management Tasks
4-10
4
CLI – Specify the management interface, IP address and default gateway.
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the stack to be
dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the management
station is attached, set the IP Address Mode to DHCP or BOOTP. Click Apply to
save your changes. Then click Restart DHCP to immediately request a new
address. Note that the stack will also broadcast a request for IP configuration
settings on each power reset.
Figure 4-8 IP Interface Configuration - DHCP
Note: If you lose your management connection, make a console connection to the
Master unit and enter “show ip interface” to determine the new stack address.
CLI – Specify the management interface, and set the IP address mode to DHCP or
BOOTP, and then enter the “ip dhcp restart” command.
Console#config
Console(config)#interface vlan 1
24-1
Console(config-if)#ip address 10.1.0.253 255.255.255.0 35-1
Console(config-if)#exit
Console(config)#ip default-gateway 10.1.0.254
35-2
Console(config)#
Console#config
Console(config)#interface vlan 1
24-1
Console(config-if)#ip address dhcp 35-1
Console(config-if)#end
Console#ip dhcp restart
35-3
Console#show ip interface 35-4
IP Address and Netmask: 192.168.0.100 255.255.255.0 on VLAN 1,
Address Mode: DHCP
Console#