Edge Products ES3528-WDM - Manual (Page 507)

IGMP Snooping Commands
33-3
33
ip igmp snooping version
This command configures the IGMP snooping version. Use the no form to restore
the default.
Syntax
ip igmp snooping version {1 | 2 | 3}
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
• 3 - IGMP Version 3
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
• All systems on the subnet must support the same version. If there are legacy
devices in your network that only support Version 1, you will also have to
configure this switch to use Version 1.
• Some commands are only enabled for IGMPv2 and v3 snooping, including ip
igmp snooping query-max-response-time, ip igmp snooping
query-interval, and ip igmp snooping immediate-leave.
Example
The following configures the switch to use IGMP Version 1:
ip igmp snooping leave-proxy
This command suppresses leave messages unless received from the last member
port in the group. Use the no form to restore the default.
Syntax
ip igmp snooping leave-proxy
no ip igmp snooping leave-proxy
Default Setting
Disabled
Command Mode
Global Configuration
Console(config)#ip igmp snooping version 1
Console(config)#