Sealey VS8196 - Manual (Page 11)

Page 11 Original Language Version VS8196.V2 Issue:2(P)-20/08/13
NOTE: Please check following methods to avoid injury.
 FOR WALLS
:
For inspecting the wall cavities, ensure you turn off the
circuit breaker to the whole premises before using the tool.
 FOR PIPES: If you suspect a metal pipe could contain a live electrical
voltage, have a qualified electrician check the pipe before using.
 FOR AUTOMOBILES
:
Ensure the automobile is not running during
inspection. Metal and liquid under the bonnet may be hot. Don’t get oil or
fuel on the imager head.
4.3 Battery Precautions
y Remove the batteries while cleaning the tool.
y Remove the batteries before storing the tool for a long period of time to
prevent battery leakage from damaging battery compartment.
y When necessary, replace all four (4) batteries with new ones.
y Use only the size and type of batteries specified.
y Be sure to install batteries with the correct polarity as indicated in the battery
compartment.
y Properly dispose of batteries. Exposure to high temperatures can cause
batteries to explode. Do not dispose in fire.
4.4 Maintenance Instructions
NOTE: Make sure the batteries have been removed from the tool before
performing maintenance.
y Tool maintenance must be performed by qualified repair personnel.
y When maintaining, use only identical replacement components.
y Do not attempt to take apart unless directed by the manual.
y Follow instructions to replace accessories.
y Do not use acetone to clean the tool. Instead, use alcohol. Avoid rubbing too
hard on the LCD screen. After using, wipe the display unit clean with
a dry cloth.
y Stop using the tool if it starts smoking or emitting noxious fumes.
y Always handle the tool with care. It is not shock-resistant and should not be
banged or dropped.
y Do not disassemble the tool beyond what is shown in the manual. Doing so
will void your warranty.