Sealey SA44 - Manual

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to
when using this equipment.

WARNING! Disconnect from air supply before
changing accessories or servicing.

Maintain the grinder in good condition (use an
authorised service agent).

Replace or repair damaged parts. Use genuine
parts only. Unauthorised parts may be dangerous
and will invalidate the warranty.

Use in a suitable work area. Keep area free from
unrelated materials and ensure that there is
adequate lighting.

Before each use check abrasive disc for condition.
If worn or damaged replace immediately.

Ensure the speed rating (rpm) of the disc is the
same as, or greater than, the speed rating of the
grinder.

Ensure there are no flammable or combustible materials near the work area.
 WARNING! Always wear approved eye (or face) and hand protection when operating the grinder.

Use face, dust, or respiratory protection in accordance with COSHH regulations.

Depending on the task, grinder noise level may exceed 85dB in which case wear safety ear defenders.

Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long
hair.

Wear appropriate protective clothing and keep hands and body clear of working parts.

Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.

Keep children and unauthorised persons away from the working area.

Check moving parts alignment on a regular basis.

Ensure workpiece is secure before operating the grinder. Never hold a workpiece by hand.

Check the workpiece to ensure there are no protruding screws, bolts, nuts etc.

Avoid unintentional starting.
 WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure 90psi.

Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure
that all connections are secure.

Prolonged exposure to vibration from this grinder poses a health risk. It is the owner’s responsibility to
correctly assess the potential hazard and issue guidelines for safe periods of use and offer suitable protective
equipment.

DO NOT use the grinder for a task it is not designed to perform.

DO NOT operate grinder if any parts are damaged or missing as this may cause failure and/or personal injury.
 WARNING! DO NOT grind any materials containing asbestos.

DO NOT carry the grinder by the hose, or yank the hose from the air supply.

DO NOT force, or apply heavy pressure to, the grinder, let the tool do the work.

DO NOT place air line attachments close to your face and do not point at other people or animals.

DO NOT operate grinder when you are tired or under the influence of alcohol, drugs or intoxicating medication.

DO NOT use grinder where there are flammable liquids, solids or gases such as paint solvents and including
waste wiping or cleaning rags etc.

DO NOT carry the grinder with your finger on the power lever.

DO NOT direct air from the air line at yourself or others.

When not in use disconnect from air supply and store in a safe, dry, childproof location.
INSTRUCTIONS FOR:
SA44.V3
AIR ANGLE GRINDER 100mm EXTRA HEAVY-DUTY
Original Language Version SA44.V3 Issue: 3 - 08/12/09