Edirol R-09HR - Manual (Page 48)

48
Recording
The R-09HR can be used for recording instrumental performances and taking voice memos,
but it can also be used to record cassettes or CDs using the [LINE IN Jack].
If a device or cable is connected to the [LINE IN Jack], input from the microphones is disabled. Therefore,
it is not possible to mix microphone and line input during recording. If there is sound input via both the
[LINE IN Jack] and the [MIC Input Jack], only the sound from the line input is recorded.
This example describes recording from a CD player to the R-
09HR.
fig.power-onoff-e.eps_80
1.
Turn on power to the R-09HR.
Turn on the R-09HR’s power. See “Turning power on/off”
(p. 20).
2.
Set the sampling frequency.
“Configuring recording” (p. 34)
fig.open-set-e.eps_80
1. Show the
Press the [MENU Button] to show the
fig.recoedersetting-e.eps_80
2. Select “Recorder Setup.”
Use the [PLAY Button ] and [STOP Button ] to select
“Recorder Setup,” then press the [REC Button].
fig.setsamplingrate-e.eps_80
3. Select the sampling frequency (Sample Rate).
Use the [PREV button ] and [NEXT button ] to change
the Sample Rate value.
Recording from cassettes or CDs
Hold down
Show
Move the
cursor
up or down
Enter
Changes
the value
R-09HR_e.book 48 ページ ２００７年１２月１７日 月曜日 午後２時１６分