Edirol R-09HR User Manual
Page 40
40
Recording
fig.rec-start-e.eps_80
6.
Press the [REC Button] to begin recording.
Press the [REC Button] in recording-standby mode (while
the [REC Indicator] is blinking).
The [REC Indicator] lights up, and recording begins.
• Recording can also be started by pressing the [PLAY/PAUSE
Button
].
• If you slide the HOLD switch to the ON position after starting a
recording, the recording will not stop nor will the recording
level change even if a button is accidentally pressed.
• If a microphone or other device is connected to the [LINE IN
Jack] or [MIC Input Jack], the [Internal Mic] cannot be used.
When using the [Internal MIC], do not connect anything to the
[MIC Jack] or [LINE IN Jack].
• If the [Input Level Button] is used in recording-standby mode or
during recording, the input level will change. Be careful to not
mistakenly use the [Input Level Button].
• Power cannot be turned off during recording.
First stop the recording, then turn off the power.
fig.rec-stop-e.eps_80
7.
Press the [STOP Button
] to stop
recording.
The [REC Indicator] goes out.
Press the [PLAY/PAUSE Button
] to pause.
Press the [PLAY/PAUSE Button
] again to cancel the pause
and restart recording.
fig.song.eps_80
The display shows the recorded song.
• The song name is automatically created, e.g., R09_0001.WAV.
The four-digit number forming the latter part of the name is
arrived at by adding one to highest-numbered existing song.
• When File Name is set to “Date,” the date and time of the
recording becomes the song name.
fig.play-start-e.eps_80
8.
Play it back.
Press the [PLAY/PAUSE Button
] to listen to the just-
recorded song.
Starts
recording
Stops
recording
Play
R-09HR_e.book 40 ページ ２００７年１２月１７日 月曜日 午後２時１６分