Edirol R-09HR User Manual
Page 44
44
Recording
fig.rec-start-e.eps_80
8.
Press the [REC Button].
Press the [REC Button] while in recording-standby mode
(while the [REC Indicator] is blinking). The [REC Indicator]
lights up, and recording begins.
• Recording can also be started by pressing the [PLAY/PAUSE
Button
].
• If you slide the HOLD switch to the ON position after starting a
recording, the recording will not stop nor will the recording
level change even if a button is accidentally pressed.
• When the [SPLIT Button] is pressed during recording, the file is
split at that location and saved (p. 51).
• If the [Input Level Button] is used during recording, the input
level will change. Be careful to not mistakenly use the [Input
Level Button].
• Power cannot be turned off during recording.
First stop the recording, then turn off the power.
fig.rec-stop-e.eps_80
9.
Press the [STOP Button
] to stop
recording.
The [REC Indicator] goes out.
Press the [PLAY/PAUSE Button
] to pause.
Press the [PLAY/PAUSE Button
] again to cancel the pause
and restart recording.
fig.song.eps_80
The display shows the recorded song.
• The song name is automatically created, e.g., R09_0001.WAV.
The four-digit number forming the latter part of the name is
arrived at by adding one to highest-numbered existing song.
• When File Name is set to “Date,” the date and time of the
recording becomes the song name.
fig.play-start-e.eps_80
10.
Play it back.
Press the [PLAY/PAUSE Button
] to listen to the just-
recorded song.
Starts
recording
Stops
recording
Play
R-09HR_e.book 44 ページ ２００７年１２月１７日 月曜日 午後２時１６分