Eclipse - Fujitsu Ten CD5415 - Manual (Page 83)

83
Before installation
No. Item Q'ty
1 Main unit 1
2 Mounting sleeve 1
3 Side bracket 2
4 Rear bracket 1
5 Bezel 1
6 Bushing 1
7 Self-tapping screw (6 x 16 mm) 1
8 Stud bolt 1
9 Flat head screw (red: 5 x 8 mm) 4
10 Hex-head bolt (red: 5 x 8 mm) 4
11 Hex-head bolt (6 x 20 mm) 1
12 Hex nut (5 mm) 1
13 Hex nut (6 mm) 1
14 Interconnecting cable 1
Components
Before installation
●
Note
●
Be sure to disconnect the vehicle battery's negative terminal
before installing the receiver.
Installation angle
In order to maintain proper functioning, install the unit within an angle
of 30 degrees from horizontal (standard). If this is not done, sound
skipping or ejection of the CD may occur.
FRONT
STANDARD
WITHIN AN ANGLE
OF 30 DEGREES