Eclipse - Fujitsu Ten CD5415 - Manual (Page 67)

67
How to operate the tuner with an optional HD RADIO tuner connected (U.S.A. only)
[SEL] button [FM AM] button
[ ] button
[ ] button
First, press the [FM AM] button to start tuner operation.
There are automatic and manual methods for setting stations in
memory. The receiver will accept up to 24 stations in memory: 6 in
AM and 18 in FM (6 each for FM1, FM2 and FM3.) (Initial setting)
Tuning to a station
Press the [FM AM] button for less than one second to
switch to the desired FM or AM bands.
Radio bands will switch from FM1
➔ FM2 ➔ FM3 ➔ AM in
order each time the button is pressed.
1
ATTENTION
If the optional SIRIUS satellite radio tuner unit is connected, radio
mode will be switched between the satellite radio mode and FM
AM radio mode by pressing the [FM AM] button for more than
one second.
Turn the [SEL] button to the left or right to tune to a
station.
Turn to the right: Tunes to higher frequencies.
Turn to the left: Tunes to lower frequencies.
2
Press the [ ] or [ ] button to start the automatic station
search.
[ ] button: Starts searching toward higher frequencies.
[ ] button: Starts searching toward lower frequencies.
3
ATTENTION
At times, it may be difficult to maintain optimum reception
because the antenna affixed to your vehicle is in motion
constantly (relative to the broadcast antenna), encountering
continuous variation in the received radio signal's strength. Other
factors affecting reception include interference from natural
obstacles, sign posts, etc.