Eclipse - Fujitsu Ten CD5415 User Manual
Page 50
50
How to operate the tuner
[FM AM] button
Changing the reception sensitivity for automatic scanning
Check that the deck is in standby mode.
1
Press and hold the [FM AM] button, then button [1], and
hold both for more than three seconds.
2
The mode switches between AUTO mode and DX mode each
time the buttons are pressed.
The deck lets you select the reception sensitivity to be used for
automatic scanning of stations. The two sensitivity modes available
for this deck are AUTO mode and DX mode.
AUTO Mode
During automatic scanning, the reception sensitivity
switches automatically to one of two levels. Initially the
reception sensitivity is set to the low level so that only
stations with strong signals are received. If no stations
could be received, the reception sensitivity is increased
so that stations with weaker signals can also be
received.
DX Mode
Because the reception sensitivity for automatic scanning
is set to the high level from the start, even stations with
weaker signals can be received. (Signal crossover may
result in some stations being hard to hear.)
ATTENTION
When an optional HD Radio tuner unit is connected, reception
sensitivity is set to the AUTO Mode. The DX Mode is unavailable.
(U.S.A. only)
Button [1]