Eclipse - Fujitsu Ten CD5415 - Manual (Page 21)

21
ESN security operating procedure
How to turn the security indicator on/off
With the unit in standby, press button [2], then the [DISP
FUNC] button and hold both for more than one second.
1
[IND. FLASH] or [IND. -----] appears on the display. 2
[IND. FLASH] means the security indicator will flash when the
vehicle’s ignition is off, and [IND. -----] means it will not. Repeat
the above steps to reactivate the flash mode.
Once ESN security is activated, the indicator flashes whenever the
vehicle’s ignition is turned off, warning potential thieves that the unit
is protected. However, if you do not want this visible deterrent, it may
be turned off.
How to read the Electronic Serial Number
Check that the unit is in standby. 1
Press button [4], then the [DISP FUNC] button, and hold
both for more than one second. 2
[ESN] appears on the display, followed by an eight-digit
number; this number is your electronic serial number (ESN).
You may use this number to identify your Eclipse CD5415 in
the event it is recovered after being stolen.
Button [2] [DISP FUNC] button
Button [4]