Edirol PC-80 - Manual (Page 86)

86
System settings for the PC-80
fig.util*
1
Simultaneously press the MIDI CH button and PGM CHANGE button,
and hold them down for a few moments.
The PC-80’s display will indicate “UTL,” and you will be in Utility mode.
fig.sy0
2
Press the [AUDIO SYSTEM] key on the keyboard.
“AS0” appears (blinking) in the display.
3
Use the VALUE encoder or the [1] key of the keyboard to choose “ AS1 .”
fig.enter
4
Press the ENTER button.
* If you press any other button without pressing the ENTER button, the setting will be
cancelled.
5
Use the VALUE encoder or press the [0] or [1] key of the keyboard to specify the USB audio
driver mode.
The display will indicate either “ON” or “OFF.”
6
Press the ENTER button.
* The Audio Advanced Driver On/Off setting will be applied the next time you turn on the power.
AUDIO ADVANCED DRIVER ON/OFF
Key Setting Explanation
0 ADVANCED OFF
Standard driver mode
This mode uses the standard driver provided by the operating system. You
can use this mode without installing the dedicated driver.
Audio signals can be transferred between the PC-80 and the computer with
16-bit resolution and 44.1/48 kHz sample rates. You can’t use the PC-80 soft-
ware synthesizer with this Advance Off setting.
* The PC-80 will operate at 44.1 kHz if you use 96 kHz playback or 96 kHz re-
cording.
1 ADVANCED ON
Advance mode
This mode uses a dedicated driver written specifically for the PC-80. By using
the dedicated driver, you can record and play back audio with high quality
and stable timing. We recommend that you use this mode.
Audio signals can be transferred between the PC-80 and the computer with
24-bit resolution and 44.1/48/96 kHz sample rates. Choose this mode if you’re
using software that supports 24-bit audio or software that supports ASIO.
PC-80_e.book 86 ページ ２００５年１１月１０日 木曜日 午前１１時３４分