Edirol PC-80 - Manual (Page 77)

77
Using the PC-80 as a MIDI controller keyboard
fig.util*
1
Simultaneously hold down the MIDI CH button and PGM CHANGE
button for a few moments.
The display will indicate “UTL
” and you will be in Utility mode.
fig.pnc
2
Press the keyboard key marked [SPLIT POINT] .
The indication “SPL ” starts blinking in the display.
3
Press the ENTER button .
4
Press the keyboard key that you want to specify as the Lower split point.
fig.enter
5
Press the ENTER button .
6
Press the keyboard key that you want to specify as the Upper split point.
7
Press the ENTER button .
* If you press a different button without pressing the ENTER button , the setting will be cancelled.
The split points have now been set.
* In Split mode, the MIDI channels used for transmission will be the MIDI channels specified for Upper mode
and Lower mode. ( ➔ “Setting the MIDI transmit channel” (p. 62))
Setting the split points
Split points
In Split mode, the keyboard is divided into
Lower and Upper regions, allowing you to
play separate sounds in each region.
The Lower region extends from the leftmost
key to the key you specify.
The Upper region extends from the rightmost
key to the key you specify.
The keys that specify these regions are called
the “split points.”
* “Combining two sounds (Split)” (p. 37)
Split point
Split point
Upper sound
Upper sound
Lower sound
Lower sound
C7 C6 C5 C4 C2 C2
C7 C6 C5 C4 C2 C2
C7 C6 C5 C4 C2 C2
C7 C6 C5 C4 C2 C2
2 1 3, 5, 7 4, 6
PC-80_e.book 77 ページ ２００５年１１月１０日 木曜日 午前１１時３４分