Epson 300 - Manual (Page 61)

Operation
The
P power light is on but nothing prints.
Cause What to do
The interface cable is not
plugged in securely. Confirm that the cable is securely
fastened to the printer and the
computer. If the cable is connected
correctly, perform a printer operation
check as described on page 6-3.
Your interface cable does not
meet both the printer and
computer specifications. Use an interface cable that meets both
printer and computer specifications.
See page 1-5.
Your software is not properly
set up for your printer. Make sure that your printer is selected
in your software.
If you cannot select your printer,
install or reinstall the printer software
as described in Chapter 2.
Nothing prints and several of the control panel lights are on or
flashing.
Cause What to do
Several common printer
errors have occurred at once. Use the “Error indicators” table on
page 6-2 to determine what
combination of errors may have
occurred, and try the recommended
solutions.
6
Tr
oub
lesh
o
o
ting
R
Hudson++ Ref. Guide
Rev.d
A5 size Chapter 6
04-30-98 DR, pass 3
Troubleshooting 6-7