Eclipse - Fujitsu Ten CD8454 - Manual (Page 99)

99
How to operate the Sound Adjustment Mode
About Sound Adjustment Mode
How to operate the Sound Adjustment Mode
Normal mode Pro mode
(See page 108) Graphic equalizer
(Simplified)
(See page 113)
(See page 128) Time alignment
(See page 118) (See page 130) Crossover
(See page 119) (See page 132) Multi-harmonizer
(See page 120) (See page 133) Non-fader phase
BASS/TREBLE * 2
(single-band * 1 )
(See page 111)
(See page 122) Parametric equalizer
This deck is equipped with two different sound adjustment modes:
normal mode and pro mode.
In normal mode, the acoustic characteristics inside the vehicle can
be adjusted using comparatively simple settings. In addition, it
corresponds to basic sound systems which comprise front speakers,
rear speakers and an added sub-woofer if necessary.
In pro mode, the sound quality characteristics can be adjusted item
by item using more sophisticated settings than in normal mode. In
addition, the adjustments can be made to suit 3-way speaker system
where the front speaker, rear speaker and non-fader output can be
set to Hi (treble range) Mid (medium range) or Low (bass range).
Refer to the table below and to the operations for each mode for
details of each mode.
* 1: In normal mode, the parametric equalizer is adjusted during EQ
mode.
* 2: Adjusted during audio control mode (see page 42).
The following adjustments can be made in normal mode and pro
mode respectively.
(See page 105)
E-iSERV sound effect
customizations
(Parametric equalizer)
(Simplified)
(See page 105)
(See page 105)
E-iSERV sound effect
customizations
(Time alignment)
(See page 105) (See page 105)
E-iSERV sound effect
customizations
(Crossover)