Eclipse - Fujitsu Ten CD8454 - Manual (Page 105)

105
How to operate the Sound Adjustment Mode
When original sounds are converted to MP3/WMA and Memory
Stick (ATRAC3) format, frequency ranges that are not normally
audible to the human ear are compressed. The multi-
harmonizer can be used to play back these compressed
sounds at as close to their original form as possible so that
clear and powerful sound can be enjoyed.
Multi-harmonizer
The sounds that are output from woofers include sounds that
are in the same frequency ranges that are output from the front
and rear speakers, and under the various conditions that can
occur inside vehicle compartments, some of these sounds may
cancel each other out. This phenomenon can be eliminated by
changing the phase of the woofer.
The phase of the woofer can be set to normal timing (in which
the output timing between the front and rear speakers and the
woofer is the same) or reverse timing (in which the output
timing between the front and rear speakers and the woofer is
different), depending on the vehicle compartment conditions.
Non-fader phase
The parametric equalizer, time alignment, and crossover
setting can be adjusted using this deck, or through the Eclipse
web site. (Settings can be stored on Memory Stick.)
E-iSERV sound effect customizations