Eclipse - Fujitsu Ten CD8454 - Manual (Page 109)

109
How to operate the Sound Adjustment Mode
ATTENTION
The initial EQ settings are factory preset.
Fine-tuning EQ functions
Fine adjustments can be made in each equalizer mode.
Select the equalizer mode.
Refer to the section "Switching equalizer modes" on page
108.
Turn the [SEL] button to select the frequency to be
adjusted.
When the button is turned, the frequency changes in the
following order.
63Hz ↔ 100Hz ↔ 160Hz ↔ 250Hz ↔ 400Hz ↔ 630Hz ↔
1kHz ↔ 1.6kHz ↔ 2.5kHz ↔ 4kHz ↔ 6.3kHz ↔ 10kHz ↔
16kHz
Press the [SEEK /FAST ] button.
This adjusts the frequency level.
[SEEK
] button: Increases level.
[FAST ] button: Decreases level.
Hold down a button, [1] to [5], for more than two
seconds to preset a value.
The preset value is overwritten by the value set using the
above steps.
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode.
6
5
4
3
2
1
[SOUND] button
[SEL] button
[SEEK ] button
[FAST ] button [RTN] button
Buttons [1] to [5]
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode. 5
4