Eclipse - Fujitsu Ten CD8454 - Manual (Page 43)

43
Basic operation
Various audio control modes may be fine-tuned using this
procedure.
Modes will switch in the order shown below each time the
button is pressed.
Switching audio control modes
Press the [AUDIO CONTROL] button for less than one
second to select the item to be adjusted. 1
*1: When the sound adjustment mode is in normal mode, this
adjustment is not available. (Refer to page 107.)
*2: If the position selector is "ON", this adjustment is not available.
(Refer to page 114.)
*3: NON-FADER output does not reflect BASS, TREBLE, LOUDNESS
and EQUALIZER settings.
*4: Setting cannot be made in FM mode.
VOL TREB BASS *
1 * 1
BAL*
2
FAD*
2
NON-F *
3
SVC *
4
Adjusts volume.
Turn the [AUDIO CONTROL] button to the left or right.
Turn to the right: Increases the volume.
Turn to the left:
Decreases the volume.
VOL (VOLUME) Mode
Adjusts bass level. Bass mode can be adjusted for each
source (CDP/CDC, FM and AM).
Turn the [AUDIO CONTROL] button to the left or right.
Turn to the right: Emphasizes low sounds.
Turn to the left:
Softens low sounds.
BASS Mode
[AUDIO CONTROL] button