Ella Moss Automobile Parts User Manual
348 fuel injection conversion, Installation instructions
Table of contents
Document Outline
- 366-348 Fuel Injection Conversion
- Installation Instructions
- 1975-1980 MGB
- with a Zenith Stromberg Carburetor
- Introduction
- Tools Needed
- Before You Begin
- Installation Part 1 – Prepare the Vehicle, Drain Fluids
- Part 2 - Remove the ZS Carb
- Installation Part 3-Modification of the Heat Shield
- Installation Part 4 - Fitting the Throttle Body
- Installation Part 5 - Laying the Harness in Place
- Installation Part 6 - Connecting the Harness to the Throttle Body
- Installation Part 7 – Installing the Manifold Absolute Pressure (MAP) Sensor
- Installation Part 9- Tapping into the Tachometer Wire
- Installation Part 10- Terminating & Connecting the Fuel Injection Harness
- Installation Part 11- Connecting the Throttle Cable
- Installation Part 12- Installing the Fuel Filter & Hose
- Installation Part 13- Vacuum Connection, Distributor to Throttle Body
- Installation Part 14- Vacuum Connection, MAP Sensor to Throttle Body
- This completes Part 14 of the installation
- Installation Part 15- Air Intake & Filter
- Installation Part 16 - Fuel Return Hose
- Installation Part 16.5 - Fuel Pump Inertia Switch
- Installation Part 17 – Removing the Stock Fuel Pump
- Installation Part 18 – Fuel Return Hose & Pump Power Wire
- Installation Part 19 – Connecting the High Pressure Fuel Pump
- Installation Part 20 – Mounting the High Pressure Fuel Pump
- Installation Part 21 – Connecting the Fuel return Hose in the Trunk
- Installation Part 21.1 – Fuel Filler Neck, Early Hose (to early 1978)
- Installation Part 21.2 – Fuel Filler Neck, Late Hose (after early 1978)
- Installation Part 22 – Installing the ECU
- Installation Part 23 – Testing the Fuel Injection Wiring & Plumbing
- Installation Part 24 – Refilling to Cooling System
- Installation Part 25 – Starting the Engine
- Installation Part 26 – Tune Up & Maintenance
- Installation Part 27 – Troubleshooting
- Part 28 - Contents of the Kit