Ella Moss Automobile Parts - Manual (Page 18)

M:\Product Information\366-348\Instructions\366-348 MGB Fuel Injection Installation Instructions_Grant_2.doc
104.
Find the fuel injection harness connector with the
blue inner seal (47.1) Connect it to the to the ECT
sensor. The clip on the connector (47.2) should snap
into place.
366-348 Inst Fig 47
47.1
47.2
366-348 Inst Fig 48
105. Locate the 22” long piece of 3/8” heater hose
supplied in the kit (Moss #051-260). Slide a small hose
clamp (supplied in kit) over the end of the hose and push
the hose onto the water choke outlet and tighten the
hose clamp.
106.
Route the 3/8” hose (49.1) from the water choke
outlet over the top of the throttle body (49.2) and down
towards the nipple in the coolant hard line. (49.3).
Remove the cap or plug on the nipple if present.
366-348 Inst Fig 49
366-348 Inst Fig 50
49.3
49.2
366-348 Inst Fig 51
51.1
49.1
107.
Slide a small hose clamp (supplied in kit) over the
end of the 3/8” hose (51.1) and push the hose onto the
nipple. Tighten the hose clamp.
This completes part 8 of the installation.
Page 18 of 52