Ella Moss Automobile Parts - Manual (Page 42)

M:\Product Information\366-348\Instructions\366-348 MGB Fuel Injection Installation Instructions_Grant_2.doc
Part 22, continued
366-348 Inst Fig 235
281. Reinstall the carbon canisters, remembering to
tighten the nuts inside the cockpit. Reinstall the
windshield washer bottle bracket, replace the washer
bottle lid, reconnect the wires for the washer pump, and
reconnect the run-on control valve. (Fig 235)
282.
Back into the passenger’s side footwell.
366-348 Inst Fig 236 366-348 Inst Fig 237
366-348 Inst Fig 239
366-348 Inst Fig 238
236.1
283.
Position the ECU with the mounting flanges up and
the rectangular white plastic plug receptacles facing the
passenger seat. (Fig 236)
284.
Find the #8 x 1” self-tapping screws supplied in the
kit and slip one through the left rear hole in the mounting
flange (236.1). Remember, rear is toward the back of the
car…
285.
Slip a plastic spacer over the screw. (Fig 237)
286.
Take a small piece of masking tape and stretch it
over the screw to hold the screw and spacer in place on
the ECU while you install it. (Fig 238 & 239)
287.
Repeat with two additional screws on the right-hand
side next to the kick panel.
288.
Hold the ECU with the three screws and spacers up
against the sheetmetal, lining up the screws with the
three hole locations. Gently /carefully start each screw.
Once all three screws are started, pull the tape out. Then
tighten the screws to secure the ECU in place (do not
over tighten the screws or they will strip out!). (Fig 240)
366-348 Inst Fig 240
Page 42 of 52