Extron Electronics MAV Plus Series - Manual (Page 126)

4-19 CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide
Command/response table for IP SIS commands (continued)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
IP setup commands (continued)
Set e-mail events for recipient Esc X41 , X43 , X44 , X44 , ..., X44 EM Ipe X45 You must first have set an e-mail
recipient for the e-mail account
number(
X41 ), using the separate
Set e-mail recipient (CR) command.
Example for CrossPoint 450 Plus 3232:
Esc 72,3,1,2,8,32,98,99EM Ipr•[email protected],
E-mail account #72, JSmith, will
receive fail/missing and fixed/
restored messages for input
signals 1,2,8,and 32; fans; and
power supplies.
Read e-mail events for recipient Esc X41 EM X44 , X44 , X44 ..., X44
Response description: Notify-what?, inputs 1-32 (inputs above the matrix size are always 0) fans PS
Example for CrossPoint 450 Plus 3232: Esc 72EM See below
Response:
Notify failed and fixed
3, 1 1 0 0 0 0 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
01 Input: 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 Fans
Power Supplies
E-mail input 8 status E-mail power supply and fan status Ignore input 16
0 0 0 0 0 0 0 0 1 1 1
Example for MAV Plus 1616: Esc 72EM See below
Response:
Notify failed and fixed
3, 1 1 0 0 0 0 0 1 0 0 0 0 0 0 0 0 1
01 Input: 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 Power Supply
E-mail input 8 status Ignore input 16
Set DHCP on or off Esc X46 DH Idh X46
Read DHCP status Esc DH X46
Set serial port parameters Esc X47 * X48 , X49 , X50 , X51 CP
Cpn X47 •Cty X48 , X49 , X50 , X51
Read serial port parameters Esc X47 CP X48 , X49 , X50 , X51
Set mode Esc X47 * X52 CY Cpn X47 •Cty X52
Read mode Esc X47 CY X52
Set verbose mode Esc X53 CV Vrb X53
Read verbose mode Esc CV X53
Special Characters
The HTML language reserves certain characters for specific functions. The switcher
will not accept these characters as part of preset names, the switcher’s name,
passwords, or locally created file names.
The switcher rejects the following characters:
{space (spaces are ok for names)} + } ~ , @ = ‘ [ ] { } < > ’ “ semicolon (;)
colon (:) | \ and ?.