Casio PL-40R 2 - Manual (Page 28)

Using the Sequencer
E-60
6.
Press the START/STOP button to start
playback of the selected track.
7.
When playback reaches the point from which
you want to modify the track contents, start
playing the new notes on the keyboard.
Š Recording starts and playback of the track’s
current contents stops as soon as you play
something on the keyboard.
8.
After you are finished playing what you want,
press the START/STOP button to stop
recording and change to the sequencer’s
playback screen.
Š You can change the playback tone after starting playback
of the track’s contents in step 6, but the tone setting you
make is not recorded. After you start punch in recording (in
step 7), any changes you make in parameter settings are
recorded just as they are during normal recording.
You can use the following procedure to change the initial
mixer, tempo and other settings stored in the song header.
1.
Press the SEQUENCER button.
2.
Select the song area that contains the song
whose header data you want to change.
Š Use the [+]/[–] buttons or the selector dial to select
a song area number in the range of 1 to 10.
3.
Set the tempo, mixer, and other song header
parameters you want.
4.
Press the RECORD button.
Š This causes the current panel settings to replace
the song header parameter settings of the
currently selected song.
Š Press the EXIT/NO button to change from the
remaining memory screen to the record standby
screen (which shows the tone and rhythm). The
record standby screen appears automatically
after about 10 seconds if you do not perform any
operation while the remaining memory screen is
on the display.
5.
Press the EXIT/NO button.
Use the following procedure when you want to play back the
contents of sequencer memory.
Š Skip steps 1 and 2 of the following procedure if you have
just finished a real-time recording operation.
1.
Press the SEQUENCER button.
Š This causes the button’s indicator lamp to light,
indicating that sequencer is turned on.
2.
Select the user song area that contains the
song you want to play back.
Š Use the [+] and [–] buttons or the selector dial to
select the song area (Song 1~10).
3.
Press the START/STOP button to start
playback.
Š Use the TEMPO buttons [ ] and [ ] to adjust
the playback tempo.
Š See the notes below for other operations you can
perform during playback.
4.
Press the START/STOP button again to stop
playback.
Š Pressing the START/STOP button starts playback from the
beginning of the selected song.
Š You can play along on the keyboard during sequencer
playback. You can use layer and split for keyboard play.
Š You can use the mixer to adjust the volume level and
stereo points of the playback track. Such settings are
output from MIDI OUT when they are made.
Š You cannot change the MODE button setting during
sequencer playback.
Š During song playback, you can display a level meter screen
that shows the volume level of each part, as well as the
each part’s on/off status. See “Level Meter Screen” on
page E-13 for more information.
Changing Song Header Data
To change the song header data
Playing Back from Sequencer
Memory
To play back from Sequencer memory
426-E-062A
PL40NE01-1.book 60 ページ ２００２年７月２３日 火曜日 午後６時５２分