Casio PL-40R 2 - Manual (Page 2)

Applying Effects to Tones
E-34
1.
Press the EFFECT/(L. METER) button.
2.
Use the [+] and [–] buttons or the selector dial to
select a reverb effect type.
Š Select “OFF” to turn off the reverb effect.
Š The display exits the reverb effect setting screen if
you do not perform any operation for about 10
seconds. You can also exit the reverb effect setting
screen by pressing the EXIT/NO button.
1.
Press the EFFECT/(L. METER) button.
2.
Press the [ ] button to display the chorus
effect setting screen.
3.
Use the [+] and [–] buttons or the selector dial to
select a chorus effect type.
Š Select “OFF” to turn off the chorus effect.
Š The display exits the chorus effect setting screen
if you do not perform any operation for about 10
seconds. You can also exit the chorus effect
setting screen by pressing the EXIT/NO button.
Š Playing a demo tune (page E-11) automatically changes
the effect to the one that is assigned to the tune. You
cannot change or cancel a demo tune effect.
Š Changing the effect setting while sound is being output by
the piano causes a slight break in the sound when the
effect changes.
Š A number of tones, called “DSP tones” include automatic
DSP settings to bring out the full effect of the tone. If you
assign a DSP tone to a keyboard part (Upper1, Upper2,
Lower1, or Lower2), DSP turns on automatically and the
DSP selection changes*
1 in accordance with the settings of
the DSP tone. Also, the mixer Mode DSP on/off setting for
the keyboard part to which the DSP tone is assigned is
turned on.*
2
*1. When the mixer Mode DSP setting is turned on for
Upper1, the DSP selection and mixer Mode DSP on/off
setting of Upper2, Lower1, and Lower2 are
unchanged, even if you assign a DSP tone to them.
*2. The mixer Mode DSP on/off settings for all the other
parts are automatically turned off. Because of this,
DSP effects previously applied to these parts are
cancelled, which can make their tone sound different.
Š Whether or not an effect is applied to the parts that are
sounding also depends on mixer Mode Reverb Send,
Chorus Send, and DSP on/off settings. See “Using the
Mixer” on page E-46 for more information.
Š The reverb and chorus of parts whose mixer Mode DSP
setting is turned on is determined by the system setting of
the keyboard settings, and not by mixer Mode settings. See
“Keyboard Settings” on page E-71 for more information.
To configure the reverb effect setting
To configure the chorus effect setting
426-E-036A
PL40NE01-1.book 34 ページ ２００２年７月２３日 火曜日 午後６時５２分