Casio PL-40R 2 - Manual (Page 19)

E-51
Registration Memory
BANK C
BANK D
You can assign setups into one of 16 areas, which you can
select using BANK buttons 1 through 4 and the four
REGISTRATION buttons. Area names range from A-1
through D-4 as shown below.
1 Use the BANK button to select the bank. Each press
of the BANK button cycle through the bank numbers
from A to D.
2 Pressing one of the REGISTRATION buttons (1 to
4) selects the corresponding area in the currently
selected bank.
Š Whenever you save a setup and assign it a setup name,
any setup data previously assigned to that name is
replaced with the new data.
1.
Select a tone and rhythm, and otherwise set up
the keyboard the way you want it.
Š See “Registration Memory Settings” on page E-50
for details on what data is stored in the
registration memory.
2.
Use the BANK button to select the bank you
want.
Š Note that the display exits the registration
memory save screen if you do not change the
setting within 10 seconds after displaying it. If
this happens, press the BANK button again.
Example:
BANK A selected.
3.
While holding down the STORE button, press a
REGISTRATION button (1 to 4).
Example:
The following display appears when you press
the 2 button.
4.
The bank (A to D) and area (1 to 4) where the
setup was stored appears on the display
momentarily. After the bank and area
disappear, release the REGISTRATION and
STORE buttons.
Area TONE RHYTHM
1 Clavi Dance 1
2 017*PercOrg2 Swing 1
3 Flute Bossa Nova 1
4 Strings 1 Broadway
Area TONE RHYTHM
1 Stereo Piano Piano Ballad 1
2 Mellow Piano Jazz Waltz
3 Stereo Piano Arpeggio 1
4 Stereo Piano 2Beat
Setup Names
To save a setup in registration
memory
426-E-053A
PL40NE01-1.book 51 ページ ２００２年７月２３日 火曜日 午後６時５２分