Casio PL-40R 2 - Manual (Page 16)

Using the Mixer
E-48
6.
Use the [+] and [–] buttons or the selector dial to
change the setting of the currently selected
parameter.
Š Press the EXIT/NO button to return to the part
selection screen in step 3 of this procedure.
Š Any time during the above procedure, you can
select another part by pressing the PART/
(MIXER) button.
7.
Repeat steps 2 through 6 to change the settings
of other parameters if you want.
Š When changing parameter settings, you can play
notes on the keyboard as you change parameter
settings to see what effect your settings have.
8.
After you are finished making the settings you
want, press the EXIT/NO button.
This section provides detailed explanations of each of the
mixer parameters, and their setting ranges.
J Tone: 271
This parameter controls the tones assigned to each part.
Š You can also change the tone assignment with the TONE
buttons. The tone you select is applied to the currently
selected part.
Š Use DRUM tone group values for the “Drum” and
“Percussion” parts.
Š You cannot select DRUM tone group values for “Bass”, or
“Chord” parts.
Š Changing the tone assigned to the Upper1 also changes
the tone assigned to Harmo1. Changing the tone assigned
to the Upper2 also changes the tone assigned to Harmo2.
J Part On/Off: On, Off
This parameter can be used to turn each part on (sounds) and
off (does not sound). The current on/off status of a part is
indicated by the on-screen level meter. See “Level Meter
Screen” on page E-13 for more information.
J Volume: 0 to 127
This parameter adjusts the overall volume of each part.
J Pan: –64 to 63*
Use this parameter to adjust the pan setting (volume balance
between the left and right speakers). A value of 0 puts the
speakers in balance, so the stereo center is halfway between
the two speakers. A smaller value shifts the stereo center left,
while a larger value shifts it right.
* When “On” is selected for the DSP you are using, these
settings are applied in accordance with each DSP
parameter setting.
The mixer lets you control the effects applied to each
individual part, making it different from the Effect Mode,
whose settings are applied to all parts in general.
J Reverb Send: 0 to 127
This parameter controls how much reverb is applied to a part.
A setting of 0 turns reverb off, while a setting of 127 applies
maximum reverb.
J Chorus Send: 0 to 127
This parameter controls how much chorus send is applied to
a part. A setting of 0 turns chorus send off, while a setting of
127 applies maximum chorus send.
Š “Chorus Send” does not work with drum sounds.
J DSP: On, Off
You can use this parameter to turn DSP off for a particular
channel, or to turn it on.
Mixer Parameters
Tone Parameters
Effect Parameters
426-E-050A
PL40NE01-1.book 48 ページ ２００２年７月２３日 火曜日 午後６時５２分