Epson I+ - Manual (Page 79)

l
If you have run a diagnostics program, you see this selection on the
OPERATION MENU:
0 - Exit and reset
In this case, when you press 0 and Enter, the system is reset. Before
selecting this option, remove the diagnostics diskette from drive A and
insert your system diskette so the system can hoot normally. If you want to
hoot from your hard disk, make sure no diskette is inserted in drive A.
Diagnostics and MS-DOS Commands
Each choice on the OPERATION MENU corresponds to an MS-DOS
command:
OPERATION MENU Choice MS-DOS Command
Setup SETUP
Format hard disk HDFMTALL
Format diskette FORMAT
System diagnostics DIAGSYS
Prepare hard disk for moving HDSIT
The other MS-DOS commands on the diagnostics diskette are:
SYSTAT
ROMBIOS
HELP
You can copy these MS-DOS commands, with the exception of
DIAGSYS, to your hard disk or to a directory on another floppy disk. You
can then execute the program as an MS-DOS command without loading
the diagnostics diskette. To copy these commands, use the COPY command
described in your MS-DOS manual.
1-3